Multi Tech Equipment MTA128ST - Manual (Page 26)

AT Commands, S-Registers, and Result Codes
26
AT Commands by Function
Command Execution
AT Attention code
A/ Repeat AT Command
Return or Enter Command execution
+++AT<CR> In-band escape code
<BREAK>AT<CR> Out-of-band escape code
General Information Commands
In Display Product Information
Ln List Active Profile Information
!L Display Network Configuration
>MIBn Management Information Block (MIB) Information
Network Configuration Commands
**s User-User Information Element String
%A97=n Dialing Method
>A0=n Type of Coding
!C0=n Network Switch Type
!C6=n Data SPID
*!C6=n Voice SPID
!D0=n V.120 LLC Information Element
!D3=n SAPI-0 Data TEI
*!D3=n SAPI-0 Voice TEI
!DNn Disable Data DN/MSN n
*!DNn Disable Voice DN/MSN n
!ENn Enable Data DN/MSN n
*!ENn Enable Voice DN/MSN n
>MULT=N Multi-point setting
!Nn=s Data DN/MSN n
*!Nn=s Voice DN/MSN n
Serial Port Configuration Commands
&Cn DCD (Data Carrier Detect) Control
&Dn DTR (Data Terminal Ready) Control
$Dn Persistent DTR Dialing
&En Flow Control
&Mn Asynchronous Mode
@P3=n Parity
@P4=n Data
Bits
@P6=n Stop Bits
&Rn CTS (Clear To Send) Control
&RFn CTS/RTS Interaction Control
&Sn DSR (Data Set Ready) Control
$SBn Serial Port Speed
%Sn Serial Port Mode
#Xn Send Multiple Xoff Characters
General Configuration Commands
@CONFIG Configuration Menu
En
Command Mode Echo
%En Escape Sequence Options
&Fn Load Factory Profile
%Mn Management Mode
Qn Quiet Mode