Quick setup factory profiles, Quick setup example – Multi Tech Equipment MTA128ST User Manual
Page 43
Appendices
MTA128ST/NT
43
A p p e n d i x A : C o n f i g u r a t i o n P r o f i l e s
Quick Setup Factory Profiles
For quick setup, the MTA1 28ST/NT includes six Quick Setup Factory Profiles, each of which is configured for a
specific type of port operation. You can load a Quick Setup Factory Profile into active memory by using the
command &Fn, in which n is the number of the profile you wish to load. If you wish, you can then customize the
profile and store it, using the &Wcommand, so that it loads automatically when the MTA1 28ST/NT is turned
on or reset. These profiles are stored in permanent memory and are not user-configurable as such.
MTA1 28ST
&F0
Profile 0—Modem-like operation (default)
&F1
Profile 1—V. 110 async operation
&F2
Profile 2—V.120 async operation
&F3
Profile 3—X.75 async operation
&F4
Profile 4—ML-PPP async operation
&F5
Profile 5—SoftBonding Asynchronous Operation
&F6
Profile 6—HDLC Asynchronous Operation
&F7
Profile 7—CLEAR operation
MTA1 28NT
&F0
Profile 0–Modem-Like Asynchronous Operation
&F1
Profile 1–V.120 Asynchronous Operation
&F2
Profile 2–X.75 Asynchronous Operation
&F3
Profile 3–PPP Asynchronous Operation
&F4
Profile 4–SoftBonding Asynchronous Operation
&F5
Profile5–HDLC Asynchronous Operation
&F6
Profile 6–CLEAR Asynchronous Operation
Quick Setup Example
The following procedure assumes that you want to load, modify, and store Quick Setup Factory Profile 2 as
your default configuration.
1. Select the profile closest to the requirements of your application, in this case— Quick Setup Factory
Profile 2.
2. In terminal mode, type AT&F2 and press ENTER. Quick Setup Profile 2 loads into the MTA128ST/NT’s
active memory.
3.
Enter any additional AT commands that you need to customize the selected profile to your application
(see Chapter 4, AT Commands, S-Registers, and Result Codes).
4. Type AT&W0 and press ENTER to save your customized port configuration.
5. Your customized profile now loads automatically whenever the MTA128ST/NT is turned on or reset.