Multi Tech Equipment MTA128ST - Manual (Page 48)

48
Appendices
EKTS (Electronic Key Telephone Sets)
Shared Directory Numbers
Accept
Special
Type of Number
Intercom Groups
Modem Pools (Network Resource Selector)
Message Waiting
Hunting
I nterLATA Competition
5b. Northern Telecom DMS-100:
request a point-to-multipoint line with:
Line Type: Basic Rate, Functional
Electronic Key Telephone Sets (EKTS): No
Call Appearance Handling (CACH): No
Non-Initializing Terminal: No
Circuit Switched Service: Yes
Packet Switched Service: No
TEI: Dynamic
Bearer Service: Circuit Switched Voice and Data Permitted on Any B Channel (Packet Mode Data not
permitted)
6.____________________________________________________ Select a long distance carrier; note here:
____________________________________________________
7. Contact the selected long distance carrier and request Circuit-Switched 64K bps Clear Channel Access (if available).
8. Request that the telephone company provide ISDN TA configuring information (record here):
• ISDN Switch Type: ____________
• ISDN Switch Protocol Version: __
• ISDN Phone Number 1: ___________
• ISDN Phone Number 2: _______ (if 2B+D ordered)
• ISDN Line Type: _____________(point-to-point or multipoint)
• If MultiPoint, SPID Number 1: _______ (with prefix and suffix)
• If MultiPoint, SPID Number 2: ________ (with prefix and suffix)
9. If you will be using standard 5ESS or DMS-1 00, your protocol selection is complete. Fax the
information in steps 1-8 to your phone company. If you will be using 5ESS "Custom" or DMS-1 00 "Pvc1"
protocol support, continue with step 10a (5ESS Custom) or step 10b ( DMS-100 Pvc1).
10a. 5ESS Custom Line Additional Parameters
The AT&T 5ESS central office telephone switch supports a proprietary ISDN D-channel call control protocol
called "Custom" which is based on CCITT recommendations. The ISDN TA configured for switch type AT&T
5ESS will work with lines providing this protocol on 5ESS switches with software version 5E6 or later.
The ISDN TA supports the following configurations on 5ESS Custom lines:
• Point-to-Point with one phone number (recommended configuration with no POTS interface)
• Multipoint with one phone number
• Multipoint with two phone numbers (recommended configuration with POTS interface)
The requirements for the 5ESS line are shown below:
B1 Service: DMD (On-demand)
B2 Service: DMD (On-demand)
Data Class Line: PM (Point-to-MultiPoint) Max. B
Channels: 2