MITSUBISHI ELECTRIC MR-J3-T - Manual (Page 11)

2 Installing the Equipment
The procedure for the physical installation of the MR-J3-T series hardware is exactly the same
as for the MR-J3-A and MR-J3-B models. The dimensions of the MR-J3-T series amplifiers are
identical to those of the matching models of the MR-J3-A and MR-J3-B series.
NOTE Please consult the instruction manual for detailed installation instructions.
2.1 Installing the MR-J3-D01 Extension
Procedure:
ቢ
Remove the cover of the CN7 connector on the right side of the MR-J3-T housing.
ባ
Position the MR-J3-D01 extension over the upper and lower mounting points 1 on the ser-
vo amplifier, then press the extension into place so that the lugs click into position in the up-
per and lower mounting points 2. This also connects the extension to the amplifier via con-
nector CN7 on the amplifier.
ቤ
Fasten the extension securely to the servo amplifier with the M4 screw (included) as
shown in Fig. 2-2.
Installing the Equipment Installing the MR-J3-D01 Extension
MR-J3-T 2 - 3
Fig. 2-1: Fixing points of the extension MR-J3-D01
Upper mounting
point 2
Cover for CN7
connector
Upper mounting
point 1
Lower mounting
point 1 Lower mounting
point 2