Monster Power HTS5000 - Manual (Page 14)

A) Outlet Pair Always On (Unswitched): For components (including your VCR, TV, etc.) that need to retain
memory, set left slide switch to UNSWITCHED and the right slide switch to either DELAY or NO DELAY (fig. 2a).
B) Outlet Pair Switched On: Set the left slide switch to SWITCHED and the right slide switch to NO DELAY.
(fig. 2b). The outlet pair will be “live” once the PowerCenter is switched on by pressing the front panel ON
button or by external signal when the NORMAL/REMOTE switch is set to REMOTE (see STEP 3 and STEP 4).
However, it will remain active for approximately 10 seconds after switching off the PowerCenter.
C) Outlet Pair Switched On After Delay: Set the left slide switch to SWITCHED and the right slide switch
to DELAY (fig. 2c). When the PowerCenter is switched on by pressing the front panel ON button or by
external signal, the outlet pair will be “live” after a delay set by the DELAY TIME slide switch. However,
the outlet pair will be turned off immediately once the PowerCenter is switched off by pressing the front
panel OFF button or by external signal.
D) Delay Time Switch: Set to the SHORT position, outlets will receive power after an approximate six second
delay, once the PowerCenter is switched on (fig. 2d). Set to the LONG position, outlets will receive power
after an approximate twenty second delay, once the PowerCenter is switched on. This is the recommended
delay setting for tube-based products.
NOTE: This switch affects all outlet pairs located on the back panel, if the outlet pair switched on
after delay is selected.
E) Trigger Out Programming Switch: Set to the DELAY position, the 12 volt remote trigger will power
an external device after a delay set by the DELAY TIME slide switch once the PowerCenter is switched on
(fig. 2e). Set to the NO DELAY position, the 12 volt trigger powers an external device as soon as the
PowerCenter is switched on.
8