Monster Power HTS5000 - Manual (Page 20)

STEP 8 Video AC Outlet Hookup
Isolated Clean Power Stage 4 Video Filter: Optimized to reduce noise generated by video equipment.
Isolates video components from connected digital, analog audio and video components for maximum rejection
of interference.
NOTE:
You may want to program these outlets to be “unswitched” (see page 7, fig. 2a) because some components perform best
when powered continuously. A VCR, for example, should be plugged into one of these outlets to avoid the hassle
of resetting its clock when power is interrupted. Whether you turn your PowerCenter on or off, any component
plugged into these outlets can receive power continuously as long as your PowerCenter is plugged into a properly
grounded 120-volt wall socket and the OUTLET PROGRAMMING SWITCHES for the outlet pair are set to “unswitched”.
You can plug any type of analog video component (e.g., VCR, camcorder) into these two Video AC outlets.
A) Attach a Monster Power ® ID label to each component’s power cord before you plug it into the appropriate
color-coded PowerCenter outlet.
B) VCR: Plug your VCR’s power cord into the PowerCenter’s corresponding
AV RECEIVER outlet.
C) TV: Plug your TV’s power cord into the corresponding TV outlet.
GROUND
IN OUT
IN OUT
IN OUT
CABLE TV
SATELLITE
ANTENNA
PHONE
OUT 1 IN
OUT 2
BREAKER 15A
PRESS TO RESET 1800W MAX TOTAL
2 1 3 4 5
DC IN
9~12V 300MA
REMOTE
AC IN
110V
REMOTE
NORMAL
DC OUT 9~12V 300MA
NO DELAY DELAY
OUTLET PROGRAMMING SWITCHES
DELAY TIME
SWITCH LONG
(20 seconds) SHORT (6 seconds)
TRIGGER OUT
SWITCH
UNSWITCHED SWITCHED DELAY NO DELAY
1
2
3
5
4
14