Monster Power HTS5000 - Manual (Page 18)

STEP 6 High Current Audio AC Outlet Hookup
Isolated Clean Power ™ Stage 4 Ultra-High Audio Current Filter: Optimized for maximum noise rejection,
while providing maximum current to high current audio components.
NOTE:
These outlets are designed to deliver maximum current to power hungry components such as power amplifiers
and receivers.
You may want to program these outlets to be “switched on after delay” (see page 7, fig. 2c) to enable sequential
power activation. This way, power amplifiers are turned on last and turned off first, preventing the “thump”
from getting to your speakers. See “STEP 2: Outlet Programming” (page 7) for details.
A) Attach a Monster Power ® ID label to each component’s power cord before you plug it into
the appropriate color-coded PowerCenter outlet.
B) MAIN AMP: Plug the power cord of any separate amplifiers (not preamplifiers) into the PowerCenter’s
corresponding MAIN AMP outlet.
C) SURROUND AMP: Plug your dedicated surround amplifier’s power cord into the corresponding
SURROUND AMP outlet.
12
GROUND
IN OUT
IN OUT
IN OUT
CABLE TV
SATELLITE
ANTENNA
PHONE
OUT 1 IN
OUT 2
BREAKER 15A
PRESS TO RESET 1800W MAX TOTAL
2 1 3 4 5
DC IN
9~12V 300MA
REMOTE
AC IN
110V
REMOTE
NORMAL
DC OUT 9~12V 300MA
NO DELAY DELAY
OUTLET PROGRAMMING SWITCHES
DELAY TIME
SWITCH LONG
(20 seconds) SHORT (6 seconds)
TRIGGER OUT
SWITCH
UNSWITCHED SWITCHED DELAY NO DELAY
1
2
3
5
4