Mitsumi electronic WD-Y577 - Manual (Page 12)

12 2. TV Setup
Parent menu, the Lock > Front Panel menu,
and
Setup > Edit > Lock.
• Video Settings. Change video adjustments to
get the best picture for your viewing conditions.
See “AV Menu.”
Note: You may wish to change the Picture Mode from
the default Brilliant to either Bright or Natural,
which are suitable for most home viewing envi-
ronments.
2. To program the remote control to operate A/V
devices not under NetCommand control, see
Appendix D, “Programming the Remote Control.”
TV Care
• Lamp Cartridge. When the lamp cartridge
needs replacement,
replace the lamp yourself
and save the cost of a service call. See
Appendix C for instructions.
• General Cleaning. See the cleaning recom-
mendations under “
Important Information
About Your TV.”
Assistance
• For troubleshooting, service, and product
support, see Appendix E.
• For warranty information, see the TV warranty
in the back of this book.
Installing the Remote Control Batteries
1. Remove the remote control’s back cover by gently
pressing in the tab and lifting off the cover.
2. Load the batteries, making sure the polarities (+)
and (-) are correct. For best results, insert the
negative (-) end first.
3. Snap the cover back in place.
2
1
The remote control requires two AA alkaline batteries.
Turning the TV On or Off
To turn the TV on or off, point the remote control
at the front of the TV and press the
POWER button.
Alternatively, press the POWER button on the front
panel of the TV.
If You Turn Off the TV by Mistake
1. Press POWER again within about 30 seconds,
while the lamp is still hot, to have the TV come
back on immediately.
2. If the LAMP indicator starts blinking (about 30
seconds after you shut off power), wait about
one minute for the LAMP indicator to stop
blinking and press POWER to turn the TV on
again.
When You First Power On the TV
Choosing a Language for Menus
1. Power on the TV for the first time.
2. Press to select either
English or Spanish
for all menus. You can later change the language
selection through the
Setup menu Language
option.
When you first power on the TV, the Welcome screen lets
you change the menu language.
Initial TV Setup
Use the Setup menu for basic TV setup options.
1. Press MENU to open the Main menu.
2. Press to highlight the Setup icon and display the
Setup menu.
Setup menu highlighted in TV Main menu