Mitsumi electronic WD-Y577 - Manual (Page 21)

3. TV Connections 21
Required: Two-way RF splitter, 3 coaxial cables, right
and left analog audio cables, either S-video or video
cable.
1. Connect the incoming cable or antenna to IN on the
RF splitter.
2. Connect one coaxial cable from OUT on the RF
splitter to ANTENNA IN on the VCR back panel.
3. Connect one coaxial cable from OUT on the RF
splitter to ANT 1/MAIN on the TV back panel.
Figure 9. Connecting a VCR to an Antenna or Wall Outlet Cable
4. To use the TV speakers with the VCR, connect left
(white) and right (red) audio cables from AUDIO
OUT on the VCR to INPUT AUDIO L (MONO) and
AUDIO R on the TV back panel. If your VCR is
mono (non-stereo), connect only the white (left)
cable.
5. Connect either an S-Video or composite video
cable from VIDEO OUT on the VCR back panel to
INPUT VIDEO or S-VIDEO on the TV back panel.
Connect only one type of video cable; S-Video is
recommended, if available.
065
*/ */
*/
3
-.0/0
"6%*0
065
*/
3
-
065
47*%&0
"/5&//"
065
7*%&0
"6%*0
*/
"/5&//"
065
47*%&0
065
- 3
INPUT 1
INPUT 2
L ( MONO) R
AUDIO
DIGITAL
AUDIO
OUT HDMI
1 2
Y Pb Pr
AVR
AUDIO
OUTPUT
S-VIDEO VIDEO
3
L (MONO) - AUDIO - R
Y Pb Pr (480i/480p/720p/1080i)
VIDEO: 480i /480p /720p /1080i /1080p
AUDIO: PCM STEREO
PC: VGA / W-VGA / SVGA / W-SVGA /
XGA / W-XGA / SXGA / 720p /1080p
IR EMITTER
NetCommand R
PC/DVI
AUDIO
INPUT
ANT 2 / AUX
ANT 1 / MAIN
INPUT 2
S-VIDEO VIDEO ANT 1 / MAIN


*/
065
065


VCR to an Antenna or Wall Outlet Cable