Mitsumi electronic WD-Y577 - Manual (Page 22)

22 3. TV Connections
Required: Two coaxial cables, right and left audio
cables, S-Video or composite video cable, plus cables
required to connect the TV to the cable box.
1. Connect the incoming coaxial cable to IN on the
cable box.
2. Connect one coaxial cable from OUT on the cable
box to ANTENNA IN on the VCR back panel.
3. Connect the cable box outputs to the TV as shown
in one of the options listed below. This connection
allows the TV to receive the best available signal
directly from the cable box. See the referenced
figures in this chapter, “TV Connections.”
Figure 1: Component video output to the TV’s
COMPONENT Y Pb Pr jacks; analog stereo audio to
the associated
AUDIO jacks.
OR
Figure 2: S-Video output to the TV’s
INPUT S-VIDEO jack; analog stereo audio to the
associated
AUDIO jacks.
OR
Figure 3: HDMI output to the TV’s HDMI jack.
Figure 10. Connecting a VCR to a cable box
065
*/ */
3
-.0/0
"6%*0
065
*/
3
-
065
47*%&0
"/5&//"
065
7*%&0
"UUBDI
POMZ
POF
UZQF
PG

WJEFP
DBCMF

4WJEFP

SFDPNNFOEFE
JG
BWBJMBCMF
*ODPNJOH

$BCMF
"6%*0
*/
"/5&//"
065
47*%&0
065
- 3
:
1C
1S
3
-
"6%*0
47*%&0
$"#-&
065
*/
:
1C
1S
3
-
"6%*0
47*%&0
INPUT 1
INPUT 2
L ( MONO) R
AUDIO
DIGITAL
AUDIO
OUT HDMI
1 2
Y Pb Pr
AVR
AUDIO
OUTPUT
S-VIDEO VIDEO
3
L (MONO) - AUDIO - R
Y Pb Pr (480i/480p/720p/1080i)
VIDEO: 480i /480p /720p /1080i /1080p
AUDIO: PCM STEREO
PC: VGA / W-VGA / SVGA / W-SVGA /
XGA / W-XGA / SXGA / 720p /1080p
IR EMITTER
NetCommand R
PC/DVI
AUDIO
INPUT
ANT 2 / AUX
ANT 1 / MAIN
INPUT 2
S-VIDEO VIDEO



 



4. To use the TV speakers with the VCR, connect left
(white) and right (red) audio cables from AUDIO
OUT on the VCR to INPUT AUDIO L (MONO) and
AUDIO R on the TV back panel. If your VCR is
mono (non-stereo), connect only the white (left)
cable.
5. Connect either an S-Video or composite video
cable from VIDEO OUT on the VCR back panel to
INPUT VIDEO or INPUT S-VIDEO on the TV back
panel. Connect only one type of video cable.
S-Video is recommended, if available.
Note: When using this connection configuration with
the connections used in step 3, it is possible to
view live cable programs through the VCR De-
vice. For best picture quality, however, always
view live cable programs directly from the cable
box device.
VCR to a Cable Box (Audio & Video)