Mitsumi electronic WD-Y577 - Manual (Page 43)

5. TV Menu Settings 43
Inputs Menu Options
Name
Cable Box,
Camcorder,
DVD, DVD2,
DVR, Game,
HD Disc,
Satellite, VCR,
PC,
On/Off
(ANT 1 and
ANT 2 only)
Off (HDMI only) • Assign or change names of inputs appearing in the Input Selection
menu.
• Turn Ant-1 and Ant-2 On or Off.
• Turn unused HDMI inputs Off.
• Press to move between inputs.
• Press to select a name.
• If you change the name of an input after performing NetCommand
“learning,” the IR codes you “learned” are erased.
Note: When you disconnect an HDMI device, the icon remains in the Input
Selection menu until you remove it. To remove an unwanted HDMI icon,
select
Off for the HDMI input.
Order
Put frequently used icons at the start of the Input Selection menu.
1. Press to highlight the icon to move.
2. Press
ENTER to confirm the selection.
3. Press to drag the icon to the desired position.
4. Press
ENTER to set the new position.
Learn
Y series and 734 series only
• Perform initial set-up of NetCommand control of a device.
• Add or remove individual keys from NetCommand control of a device.
See detailed instructions in chapter 6, “NetCommand.”
AVR
Y series and 734 series only
Set up NetCommand control of an A/V receiver. This set-up allows you to:
• Operate the A/V receiver’s power and volume functions with the TV’s remote control.
• Make the A/V receiver switch automatically to the correct audio input when you select a
device in the TV’s Input Selection menu.
See detailed instructions in chapter 6, “NetCommand.”
Inputs Menu
Change input names using the Inputs > Name menu.
Note:
• NetCommand IR control of home-theater devices is
available on Y series and 734 series models only.
• When you change an input name in the Name menu
and then exit the Name menu:
The name is changed
The icon in the Input Selection menu is changed
Settings are changed to the defaults for the
new device type.
On models offering NetCommand control, all
“learning” for the input is also erased.