Multi-Tech Systems BL-Series - Manual (Page 134)

134
MultiModemBL User Guide
Command Values Description
$Hn n = 1 thru 3 $H1 brings up Help Screen #1.
$H2 brings up Help Screen #2.
$H3 brings up Help Screen #3.
In n = 0,1or 2 I0 requests modem ID #.
I1 requests firmware revision #.
I2 for MTS internal use.
I9 (2834 Series only) Read Only Command enables display of Windows 95
Autodetect characteristics
L Lists all stored telephone numbers in memory.
L5 L5 lists all current operating parameters.
L6 L6 lists all current S-Register values.
L7 L7 lists additional parameters.
L8 L8 lists On-Line Diagnostics.
L9 L9 Displays Signal Strength Information.
L10 L10 Displays Signal to Noise Ratio Information.
L11 L11 Displays Noise Information.
#Ln n = 0 thru 3 * #L0 means modems negotiate V.42 Mode.
#L1 means MNP on and LAP-M off.
#L2 means LAP-M on and MNP off.
#L3 means no detection phase but go directly to
LAP-M.
Mn n = 0 thru 3 M0 means Monitor speaker always Off.
* M1 means Monitor speaker On until carrier detected
M2 means Monitor speaker always On.
M3 Monitor speaker on during dialing/off during
handshaking.
$MBn n = speed 2834 Series:
$MB75 selects CCITT V.23 mode.
$MB300 selects 300 bps on-line.
$MB1200 selects 1200 bps on-line.
$MB2400 selects 2400 bps on-line.
$MB4800 selects 4800 bps on-line.
$MB9600 selects 9600 bps on-line.
$MB14400 selects 14400 bps on-line
$MB19200 selects 19200 bps on-line
$MB28800 selects 28800 bps on-line
* $MB33600 selects 33600 bps on-line
1932 Series:
$MB75 selects CCITT V.23 mode.
$MB300 selects 300 bps on-line.
$MB1200 selects 1200 bps on-line.
$MB2400 selects 2400 bps on-line.
$MB4800 selects 4800 bps on-line.
$MB9600 selects 9600 bps on-line.
$MB14400 selects 14400 bps on-line
* $MB19200 selects 19200 bps on-line
* Factory Default Setting