Multi-Tech Systems BL-Series - Manual (Page 45)

45
Chapter 5 - Command Mode
CONTROL RS232C &C Carrier Detect Control
INTERFACE &D Data Terminal Ready Control
&R Clear To Send Control
&S Data Set Ready Control
&RF CTS/RTS Control
&SF DSR/CD Control
CONFIGURE &E0 Normal Mode
ERROR &E1 Auto-Reliable Mode
CORRECTION &E2 Reliable Mode
#L0 Negotiate V.42 Mode During Handshake
#L1 MNP On/LAPM Off
#L2 LAPM On/MNP Off
#L3 Direct LAPM/Phase Out Handshake
$A Auto-Reliable Buffering
$F Enable/Disable Auto-Reliable Fallback Character
$R Retransmit Count
$E Error Correction at 300 bps
CONFIGURE &E3 Flow Control Disabled
FLOW CONTROL &E4 Hardware Flow Control
&E5 Xon/Xoff Modem-Initiated
&E6 Xon/Xoff Modem Responds/No Pass-Through
&E7 Xon/Xoff Modem Responds/Pass-Through Allowed
#X Send Single/Multiple Xoff Characters
&E8 Enq/Ack Off
&E9 Enq/Ack On
&E10 Normal Mode Modem Flow Control Off
&E11 Normal Mode Modem Flow Control On
&E12 Computer-Initiated/Off
&E13 Computer-Initiated/On
&BS Maximum Block Size
$EB 10/11 bit Asynchronous Format
#P Parity Selection
CONFIGURE DATA &E14 Data Compression Disabled
COMPRESSION &E15 Data Compression Enabled
CONFIGURE SPEED $BA0 Speed Conversion On
CONVERSION $BA1 Speed Conversion Off
$MB Set modem speed (e.g.,$MB14400)
$SB Set serial port speed (e.g.,$SB57600)
EXECUTE $H Help
IMMEDIATE I Product Code Inquiry
ACTION I 9 Windows 95 Autodetect Inquiry (2834 Series only)
COMMANDS L5 List Current Operating Parameters
L6 List S-Register Values
L7 List additional Configuration Parameters
L8 List On-Line Diagnostics
H Off Hook
+++AT<CR> Escape Sequence: Entering Command Mode while On-Line
%E Escape Sequence Options...Entering Command Mode while On-Line
A Force Answer Mode
O Exit Command Mode/Go Back On-Line