Multi-Tech Systems BL-Series - Manual (Page 136)

136
MultiModemBL User Guide
Command Values Description
Sr? r = 0-11, 13, Reads value of Register “r” and displays
15-19, 24-26, value in 3-digit Decimal format.
30, 32 or 34...
$SBn n = speed 2834 and 1932 Series:
$SB300 selects 300 bps at serial port.
$SB1200 selects 1200 bps at serial port.
$SB2400 selects 2400 bps at serial port.
$SB4800 selects 4800 bps at serial port.
$SB9600 selects 9600 bps at serial port.
$SB19200 selects 19,200 bps at serial port.
$SB38400 selects 38,400 bps at serial port.
* $SB57600 selects 57600 bps at serial port.
$SB115200 selects 115200 bps at serial port.
1432 Series:
$SB300 selects 300 bps at serial port.
$SB1200 selects 1200 bps at serial port.
$SB2400 selects 2400 bps at serial port.
$SB4800 selects 4800 bps at serial port.
$SB9600 selects 9600 bps at serial port.
$SB19200 selects 19,200 bps at serial port.
$SB38400 selects 38,400 bps at serial port.
* $SB57600 selects 57600 bps at serial port.
&SFn n = 0 or 1 * &SF0 selects DSR follows CD.
&SF1 selects DSR independent.
&Sn n = 0, 1 or 2 &S0 forces Data Set Ready On.
* &S1 lets Data Set Ready act normally.
&S2 Data Set Ready drop is regulated by S24 on
disconnect.
$SPn n = 0 or 1 * $SP0 disables UUCP Spoofing
$SP1 enables UUCP Spoofing
T Modem will tone-dial numbers following the T.
&Tn n = 4 or 5 &T4 means Enable Response to Request for
Remote Digital Loopback.
* &T5 means Disable Response to Request for
Remote Digital Loopback.
#Tn n = 0 or 1 #T0 turns off Trellis Coded Modulation
* #T1 turns on Trellis Coded Modulation
Un n = 0, 1, 2, or 3 U0 places modem in Analog Loop Originate Mode.
U1 places modem in Analog Loop Answer Mode.
U2 places modem in Remote Digital Loopback test
mode.
U3 places modem in Local Digital Loopback test
mode.
$VDn n= 0 or 1 * $VD0 disables Voice/Data Dialing
$VD1 enables Voice/Data Dialing
* Factory Default Setting