McIntosh MVP861 - Manual (Page 22)

22
TV Aspect
This selects the proper display ratio of height and width to
match the TV/Monitor connected to the MVP861. To
change from the default setting of Wide (16:9) perform the
following steps:
1. Press the SETUP Push-button on the Remote Control
to access the On-Screen Disc Setup Menu. Then press
the Right directional Push-button to select the Video
Setup Menu Icon Tab. Refer to figure 12.
Note: If there is a Disc playing in the MVP861 press the
STOP Push-button twice before pressing the
SETUP Push-button.
2. Use the Down directional Push-button followed by
the SELECT Push-button on the Remote Control to se-
lect the TV ASPECT Menu. Refer to figure 13.
3. To change from the Wide (16:9) setting use the Up
or Down directional Push-buttons followed by the
SELECT Push-button:
(16:9) Wide Screen Mode Format ........... refer to figure 14
(4:3 PS) Conventional Screen Mode
with Pan and Scan Format .................... refer to figure 15
(4:3 LB) Conventional Screen Mode
with Letter Box Format ......................... refer to figure 16
Note: The title of the icon button-bar will change color
from yellow (the cursor color) to green indicating
the selected item.
4. Return to the Video Setup Menu by pressing the Up
directional Push-button.
5. Next continue to the TV TYPE Settings. If no other
changes are to be made in Setup Mode at this time, exit
by pressing the Down
directional Push-button to se-
lect the EXIT SETUP menu choice followed by the
SELECT Push-button and the MVP861 will return to
normal operation.
Note: The SETUP Push-button may be also pressed to
exit the setup mode.
TV Type
This selects the proper video signal format to match the
capabilities of the connected TV/Monitor. To change from
the default setting perform the following steps:
Notes: The TV Type default setting for use in North America is
NTSC and MULTI for use elsewhere. Refer to the TV/
Monitor Owner’s Manual to determine the correct
setting to be used. If the incorrect setting is chosen the
TV/Monitor may display an image without color and/or
a loss of Horizontal/Vertical Synchronization.
1. Press the SETUP Push-button on the supplied Remote
Control to access the On-Screen Disc Setup Menu.
Then press the Right directional Push-button to se-
lect the Video Menu Icon Tab. Refer to figure 12.
How to Set the Video
Figure 12
Figure 13
Figure 14