McIntosh MVP861 - Manual (Page 49)

49
How to Operate the MVP861, con’t
Figure 93
4. To start playback of the just entered program press
the PLAY Push-button. The Repeat Mode can be
activated to provide continuous playback of the
Programmed Selections. Refer to figure 94.
Note: To momentarily stop playback press either the
Pause Push-button or the STOP„ Push-
button once. To resume Program Playback
press the
PLAY
Push-
button.
5. To cancel the
Program Playback Mode press the STOP„ Push-
button twice followed by pressing the PGM (Pro-
gram) Push-button.
Reset of Microprocessors
In the unlikely event the controls of the MVP861 stop
functioning, the microprocessors can be reset by perform-
ing the following:
1. Press and hold in the
STANDBY/ON Push-but-
ton for approximately five
seconds. Refer to figure 95.
Note: This can be
performed with the
MVP861 On or in the
Standby Mode.
2. When the STANDBY/ON LED is no longer illumi-
nated release the STANDBY/ON Push-button.
3. The MVP861 will automatically switch On and
normal operation will resume.
Figure 94
Figure 95
Figure 96