McIntosh MVP861 - Manual (Page 30)

30
How to Set the Audio, con’t
Delay Time is measured in feet. The delays can be adjusted
from 1 foot to 25 feet in one foot increments for each Loud-
speaker.
Note: Before performing the Delay Time adjustments, you
must first have completed the Loudspeaker Size and
Level adjustments.
1. Measure the distances of the Loudspeakers used in the
Home
Theater
System,
from the
Listening/
Viewing
Area to
each
Loud-
speaker
to within
the near-
est foot.
2. Use the
Down
direc-
tional Push-button to select DELAY TIME followed by
pressing the SELECT Push-button on the Remote Con-
trol. Refer to figures 35 and 36.
3. Use the Down directional Push-button to select DIS-
TANCE then press the Right or Left directional
Push-buttons to select the desired measurement incre-
ments, either Feet or Meters.
4. Use the Down directional Push-button to select
FRONT Lch then use the Right or Left directional
Push-buttons to enter in the distance of the Loud-
speaker from the Listening/Viewing Area. Refer to fig-
ure 37.
Note: The Menu choice of DEFAULT will reset all the
Loudpeaker Delay Time settings.
5. Enter in the distances for the remaining Loudspeakers.
6. When all the Loudspeakers distances are entered, press
the RTRN (Return) Push-button for the SPEAKER
CONFIGURATION Menu. Then use the Down
di-
rectional Push-button to select AUDIO SETUP.
7. Next continue to the SUPER AUDIO SETUP Menu
item. If no other changes are to be made in Setup Mode
at this time, exit by pressing the Down
directional
Push-button to select the EXIT SETUP menu choice
followed by the SELECT Push-button and the MVP861
will return to normal operation.
Note: The SETUP Push-button may be also pressed to exit
the setup mode.
Figure 34
Figure 35
Figure 36
Figure 37