MITSUBISHI ELECTRIC DX-NT400E - Manual (Page 12)

12
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Connections
■ Connecting to CCTV camera, monitor, and sensor
1
MAIN
OFF
ON
AC IN ~
2 3 4
RESET
RS-232C
EMERGENCY MODE OUT 1 MODE OUT 2 MODE OUT 3 MODE OUT 4 ALARM 1 ALARM 2 ALARM 3 ALARM 4 MODE OUT 5 GND GND
CAMERA IN
IN OUT
VIDEO
OUT
GND
AUDIO
100-240V
ETHERNET
MONITOR
POWER CORD
for U.K
for the Continent
To AUDIO IN connector
To VIDEO OUT connector
To VIDEO IN connector
To AUDIO OUT connector
To CAMERA IN 1 connector
CAMERA #1
Up to 4 cameras
Processing the connecting line
Connection on the ALARM IN
terminals and the I/O terminals
Compatible power lines
ш0.32 - ш0.65 mm (AWG 28 - 22)
Cut the designated area from the
electric wire’s outer covering
(vinyl portion).
5 - 7 mm
To GND
terminal
To ALARM IN terminal
corresponds to the
CAMERA #.
SENSOR #1
CAUTION
Connecting a coaxial transmission
camera incorrectly may damage the
input terminal.
Be careful.
<Interface circuit inside the unit>
5V
5V
10k Ω
22k Ω
Input
terminal
0.047 µ F
GND
ALARM IN Input terminal
• Input Circuit
<Interface circuit inside the unit>
Output terminal
GND terminal
MODE OUT 1 to 5 Output terminal
• Output Circuit