Motorola WE800G - Manual (Page 18)

SECTION 2, INSTALLATION 2-1
Section 2:Installation
To get your network up and running:
1 Setup your hardware.
CAUTION!
Use only the Motorola supplied WE800G power adapter.
2 Insert the CD-ROM for Software Setup. Follow the prompts.
If you prefer to setup the Wireless Ethernet Bridge software
manually, refer to the Manual Software Setup found in this section.
The following sections provide detailed instructions for completing
these tasks.
Hardware Setup
Hardware setup includes:
! Antenna Installation: connecting the antenna to the unit.
! Physical Installation: where you physically place your unit.
! Electrical Connection: how to power your unit.
Antenna Installation
When shipped, the antenna is already installed on the main unit. If,
for some reason, you have to detach and than re-attach the antenna
to the main unit:
1 Take the bottom of the antenna and locate, on the right backside
of the Wireless Ethernet Bridge, the threaded knob.
2 Screw the antenna connector (counter-clockwise to remove,
clockwise to attach) on to the threaded knob until firmly seated.
When attaching, do not over-tighten.