Motorola WE800G - Manual (Page 20)

INSTALLATION SECTION 2
SECTION 2, INSTALLATION 2-3
Vertical Installation
To install the Wireless Ethernet Bridge vertically, as shown in the
illustration below:
1 Insert the Wireless Ethernet Bridge into the supplied base.
Ensure that the antenna’s location is on top, because the antenna
prevents the unit from fitting into the base. The Wireless Ethernet
Bridge’s foot slides snugly into the base to keep the unit stable.
2 Follow the procedures in “Electrical Connection to Wireless
Ethernet Bridge” located later in this section to connect the unit.
Wall Mount Installation
To mount the Wireless Ethernet Bridge on the wall, you must:
! Locate the unit as specified by the local or national codes
governing residential or business communications services.
! Follow all local standards for installing a network interface
unit/network interface device (NIU/NID).