Matsushita CF-Y5LWVYZ 1 2 - Manual (Page 36)

36
9.3.2.3. Putting LCD Side Rubber / LCD Side Damper
Conductive Cloth
externals standard
0 1mm
LCD Side Dumper
from externals 0-1mm
There must not be
overflow from externals
from externals 0-1mm
There must not be
overflow from externals
Cable Gasket Clot
Affixationh
LCD
Side Rubber 3
LCD
Side Rubber 3
10 1mm
Wide Side
Narrow Side
Attention,There
is directionality
LCD Protect Plate
LCD Tape C
Steps part
Steps part
LCD Side Dunper
0 1mm
Rib
Rib
Rib
Rib
LCD Side Cushion
Rib standard
Rib standard
0 1mm
Affixes it between the
length walls. (There
must not be overflow)
Affixes it between the
length walls. (There
must not be overflow)
Affixes it between
the length walls.
(There must not
be overflow)
Affixes it between
the length walls.
(There must not
be overflow)
Affixes it between
the length walls.
(There must not
be overflow)
Steps part corner
standard 0 1mm
Steps part corner
standard 0 1mm
The flaking off paper is peeled
off by the post-processing
0 1mm
Rib standard
0 1mm
Rib standard
Affixes in a plane plinth
(in the frame)
(LCD handling attention)
-Do not take out the vicinity of the center of the lamp side having when you take out LCD of the packing box.
(Because there is a possibility that the transformation of the lamp reflector etc. occur)
-Take out right and left both ends of the lamp side having when you take out LCD.
Affixes it between
the length walls.
(There must not be
overflow)