Matsushita CF-Y5LWVYZ 1 2 - Manual (Page 58)

58
Speaker Ring affixation
Speaker Ring affixation
Blue
Cable drawing out side
Cable drawing
out side
The speaker which has
been prepared is installed
The speaker which has
been prepared is installed
Speaker Ring must not
hang on the positioning
rib side of the speaker
The rib of the speaker is
set to the concave Top
Case part
< Speaker installation position-Red >
Soldering temperature
: 300-350 degrees
Soldering time : 3 seconds
Speaker Cable
Blue
< Speaker installation position-Blue >
The rib of SP is set to the con-
cave Top Case part
Blue
Red
Red
Red
Pin No.1(Red)
<Preparation for speaker>
Safety work
The height of the solder
height shall not be from
a magnet heaven side.
Rib side
<Line Hold Sheet 8
affixation position>
L type rib side
L type rib side
<Wire Fixation Tape affixation position>
Sticks to Cable
and affixes
A red lead fixes with the Line
Sheet (Solenoid) in the state
in this side This side of
a round pin
is passed
0
Square hole
Boss bese
Affixes in boss’s outside di-
ameter application and Top
Case’s corner hole is con-
cealed
<Spacer affixation
position>
<Pad SW Sheet affixation
position>
Pad SW Sheet
affixation
Solenoid Line Sheet
affixation
Safety work
Line Hold Sheet 8
affixation
Processes so that Ca-
ble should not stretch
Top Case’s U type slit
part is passed
This side of a round pin is passed
Thing that running aground is not
on boss heaven side along boss
side
Solenoid A’ssy
installation
The part where the axis can be
tied up is fixed into U type pro-
jection part of metal fittings
Screw(DXHM0056ZA)
Solenoid Spacer
affixation
Work notes < SCWER tightening torque >
Conclusion first time power : 0.16-0.18N m{ 1.6-1.8kgf cm }
At the repair : 0.10-0.12N m{ 1.0-1.2kgf cm }
9.3.4.11. Assembly of the Solenoid
9.3.4.12. Assembly of the Speaker