Matsushita CF-Y5LWVYZ 1 2 - Manual (Page 46)

46
9.3.3.7. Insert the Main Board
1-3mm
2-4mm
Tape
Coin Battery
Edge side central distribution
Affixation
within this range
Safety Work
Safety Work
Safety Work
Screw
(DXQT2+D25FNL)
Screw
(DXQT2+D25FNL)
MODEM Preparation goods
W-LAN Module Preparation goods
Screw
(DXQT2+D25FNL)
Memory Spreader
Screw
(DXQT2+E6FNL)
Affixes to the sheet..Does not get on the board.
Valley case
Bend with 0.5 or more
(Use the treatment device)
The adsorption sheet of the
axis for fixation is peeled off
before installs. (2 places)
Safety Work
The adsorption sheet of the
axis for fixation is peeled off
before installs. (2 places)
After the pin by which the
position is decided is inserted, a
fixed screw is tightened.
After the screw is tightened, the
pin is detached.
Slit externals match
0-1.5mm
*Does not overlap in the slit
0 2mm 0 2mm
AL Sheet externals standard
Board Label
Character
direction (Upper)
MODEM LAN Holder
MODEM CN installation
LAN CN installation
Installs so that the cable should not cross.
Pressurizes with the battery the finger is
put in the PCMCIA slot.
(Attention)
-The board is set in the receiving treatment device and works.
-When carrying to the following process, a special palette is used.
(The FPC bend in YB respect is prohibited)
The cable is processed to this part remaining. Does
not get on a top side in the main body of the battery.
Fit to
connector
affixation
9.3.3.8. Note of Wireless LAN module is inserted
<Notes when Wireless LAN Module is inserted>
Please do Board’s insertion and extraction correctly according to the direction and the procedure shown in the figure below
Please go from parallel respect to mounting Board in Board’s insertion and extraction within the range of 5 -10
Please insert in the interior completely when you insert Board.