Motorola RDU2080d - Manual (Page 52)

PROG
RAM
M
ING
FEATUR
ES
English
50
Once you have selected the channel, proceed
to enable (‘YES’) or disable (‘NO’) the scan
feature by toggling the SB2 (*) button. Once
you have set the values you need, long press
the PTT button to save an exit.
Notes:
• (*)This assumes the SB2 button is not being
programmed for a different mode.
• If the MAX CHAN setting in the radio is set to
1, the Scan Programming option will not show
(will be disabled).
PROGRAMMING BUTTONS
You can map any channel to either button B or
C as a preset channel. To enable, enter
’Programming Mode’ and choose the channel
you want to set as preset channel using the
/
buttons. Once you have selected your
channel, press and hold the B or C button for 2-
3 seconds.
A short press of either preset button (B and C)
will play a good key chirp.
When scanning, a short press of either preset
button will change the home channel to the
preset channel. The radio will display FREQ/PL
and will continue to scan from the new home
channel.
EDITING CHANNEL ALIAS NAME
To edit a channel’s alias, turn ON the radio and
press and hold the PTT button and the
/
buttons for 3 seconds. Upon entering the
‘Channel Alias Mode’, the radio will generate a
special beep. You will see the current channel
alias name and channel number blinking as
follows:
Choose the channel number you want to edit
by pressing the
/ buttons. Once you have
selected the channel number, press the PTT
button or MENU to start editing the channel