Motorola RDU2080d - Manual (Page 60)

PROG
RAM
M
ING
FEATUR
ES
English
58
Cloning Radios using the Radio to Radio
(R2R) Cloning Cable (optional accessory)
Operating Instructions
Source Radio: Radio to be cloned.
Target Radio: Radio to which the configuration
of the “Source Radio” will be copied (cloned).
1. Before beginning the cloning process, make
sure you have:
• A fully charged battery on each one of the
radios.
• Two Single Unit Chargers (SUC).
• Both radios are turned OFF.
• Both radios are of the same radio model.
2. Unplug any cables (power supply or USB
cables) from the SUCs.
3. Plug one side of the cloning cable mini
connector to one SUC. Plug the other end to
the second SUC.
Note: During the cloning process no power is
being applied to the SUC. The batteries will
not be charged. A data communication is
being established between the two radios.
4. Turn ON the “Target Radio” and place it into one
of the SUCs.
5. On the “Source Radio”, power the radio
following the sequence below:
• Long press the Push-to-Talk (PTT) and Side
Button 2 (SB2) simultaneously while turning
the radio ON.
• Wait for 3 seconds before releasing the
buttons until a distinctive audible tone is
heard.