MGE UPS Systems Switched PDU - Manual (Page 37)

3. Operations
System Administration
Creating a location description
The Set Location command specifies text that appears in the HTML control screen’s Location field. The text is
also appended to a Welcome to banner that appears when a user successfully logs in serially or through a
Telnet session.
If you do not issue this command, or if you issue this command without specifying any text, the control screen ’s
Location field will be blank and no Welcome to banner will be displayed.
To create a location description:
At the Switched PDU: prompt, type set location , followed by a descriptive name of up to 24 alphanumeric and
other typeable characters (ASCII 32 to 126 decimal - spaces are allowed). Press Enter .
Omitting any characters after typing ‘set location’ deletes any previously specified text.
Examples
The following command specifies Florida HQ as the descriptive location for the control screen and the login
banner:
Switched PDU: set location Florida HQ<Enter>
The following command deletes any previously specified location description:
Switched PDU: set location<Enter>
In this case, the control screen’s Location field will be blank, and no welcome banner will be displayed after a
successful login.
Displaying system configuration information
The Show System command displays all system configuration information.
• Firmware version
• NIC module serial number and MAC address
• Hardware revision code and Flash size
• Uptime since last system restart
• System location description
To display system configuration information:
At the Switched PDU: prompt, type show system and press Enter .
Example
System Information
F/W Version: Switched PDU Version 5.3a
NIC S/N: 1600001
MAC Address: 00-0a-9c-10-00-01
H/W Rev Code: 0
Flash Size: 1 MB
Uptime: 0 days 6 hours 14 minutes 1 second
Location: Florida HQ
301-0399-4 Rev A. - Page 37