MGE UPS Systems Switched PDU - Manual (Page 47)

4. Advanced Operations
SNMP
The Switched PDU family of products supports the Simple Network Management Protocol (SNMP). This allows
network management systems to use SNMP requests to retrieve information and control power for the
individual outlets.
The Switched PDU includes an SNMP v1 agent supporting standard MIB I and MIB II objects. A private
enterprise MIB extension is also supported to provide remote power control.
NOTE: For security, SNMP support is disabled by default.
SNMP Command Summary
Command Description
Set snmp Enables or disables SNMP support
Set snmp getcomm Sets the ‘get’ community string
Set snmp setcomm Sets the ‘set’ community string
Set snmp trapdest1 Sets a destination IP addresses for traps
Set snmp trapdest2 Sets a destination IP addresses for traps
Set snmp traptime Sets the delay for steady state condition traps
Show snmp Displays all SNMP configuration information
Enabling and Setting up SNMP Support
Switched PDU SNMP support must be enabled and configured for access to Switched PDU3 MIB objects and
generation of all Switched PDU3 traps.
Enabling/disabling SNMP support
The Switched PDU SNMP command is used to enable or disable SNMP support.
To enable SNMP support:
At the Switched PDU: prompt, type set snmp , followed by enabled or disabled and press Enter .
NOTE: A restart of the Switched PDU is required after enabling or disabling SNMP support. See Performing a
warm boot on page 39 for more information.
301-0399-4 Rev A. - Page 47