MGE UPS Systems Switched PDU - Manual (Page 40)

3. Operations
Displaying network configuration information
The Show Network command displays TCP/IP, Telnet, SSH, Web, SSL and SNMP configuration information.
• IP address, subnet mask and gateway
• Enabled-disabled status of Telnet, SSH, HTTP,SSL and SNMP support
• Telnet, SSH, and HTTP port numbers
• HTTP authentication method and SSL access setting
• Network status
See page 47 for more information on SNMP.
To display network configuration information:
At the Switched PDU: prompt, type show network and press Enter .
Example
The following command displays the network configuration information:
Switched PDU: show network<Enter>
Network Configuration
IP Address: 12.34.56.78
Subnet Mask: 255.0.0.0
Gateway: 12.34.56.1
Telnet: Enabled Port: 23
SSH: Enabled Port: 65535
HTTP: Enabled Port: 80 Security: BASIC
SSL: Enabled Access: Required
SNMP: Enabled
Network Status
Link: Up
Speed: 100 Mbps
Duplex: Full
Negotiation: Auto
HTTP Administration
NOTE: A restart is required after setting or changing ANY Telnet/Web configurations. See Performing a warm
boot on page 39 for more information.
Enabling and disabling HTTP support
The Set HTTP command is used to enable or disable HTTP support.
To enable or disable HTTP support:
At the Switched PDU: prompt, type set http , followed by enabled or disabled and press Enter .
Changing the HTTP server port
With HTTP support enabled, the HTTP server watches and responds to requests on the default HTTP port number 80.
This port number may be changed using the Set HTTP Port command.
To change the HTTP port:
At the Switched PDU: prompt, type set http port , followed by the port number and press Enter .
Example
The following changes the HTTP port number to 2048:
Switched PDU: set HTTP port 2048<Enter>
Page 40 - 301-0399-4 Rev A.