MGE UPS Systems Switched PDU - Manual (Page 39)

3. Operations
Displaying the firmware version
The Version command displays the firmware version.
To display the firmware version:
At the Switched PDU: prompt, type version and press Enter .
Performing a warm boot
The Restart command performs a warm boot of the Switched PDU.
NOTE: System user/outlet/group/port configuration or outlet states are NOT changed or reset with this
command.
To perform a warm boot:
At the Switched PDU: prompt, type restart and press Enter .
TCP/IP Administration
NOTE: A restart of the Switched PDU is required after setting or changing ANY TCP/IP configurations. See
Performing a warm boot for more information.
Setting the IP address
The Set Ipaddress command sets the TCP/IP address of the network interface controller.
To set the IP address:
At the Switched PDU: prompt, type set ipaddress , followed by the IP address and press Enter .
Example
The following command sets the IP address to 12.34.56.78:
Switched PDU: set ipaddress 12.34.56.78<Enter>
Setting the subnet mask
The Set Subnet command sets the subnet mask for the network the PT40 will be attached to.
To set the subnet mask:
At the Switched PDU: prompt, type set subnet , followed by the subnet mask and press Enter .
Example
The following command sets the subnet mask to 255.0.0.0
Switched PDU: set subnet 255.0.0.0<Enter>
Setting the gateway
The Set Gateway command sets the IP address of the default gateway the Switched PDU uses to access
external networks.
To set the gateway IP address:
At the Switched PDU: prompt, type set gateway , followed by the gateway IP address and press Enter .
Example
The following command set the gateway IP address to 12.34.56.1:
Switched PDU: set gateway 12.34.56.1<Enter>
301-0399-4 Rev A. - Page 39