Macsense Connectivity MPC-200 - Manual (Page 15)

Next, click the Advanced tab . You will then see the following property sheet: The con-
figurable properties are given in the Property list. Click the property you want to configure
and choose your desired setting from the Value drop-down menu.
The following sections describe the meaning of each property and its default value.
Connection Type
Permissible connection types are:
100BASE-TX to connect 100BASE-TX Ethernet Hubs
100BASE-TX Full Duplex to connect 100BASE-TX Full Duplex Hubs
10BASE-T (Twisted Pair) to connect 10BASE-T Ethernet Hubs
10BASE-T Full Duplex to connect 10BASE-T Full Duplex Hubs
10BASE-T No_Link_Test to connect 10BASE-T Ethernet Hubs without Link Integrity
Test
AutoSense Sense dynamically the media ports to determine the con-
nection type
The default setting is AutoSense.
Receive Buffers
The number of buffers allocated by the driver in the receive ring. The valid values are
8, 16, 32, 48, and 64. The default setting is 16.
Snooze Mode
If Snooze Mode is enabled, the card will enter snooze mode and most of its clocks will
be disconnected to save power. The card will temporarily exit from Snooze Mode to normal
operation mode upon sensing network activity, start of a transmission, or when it is being
accessed by the host.
Driver Installation for Windows 95 OSR 2
12