Macsense Connectivity MPC-200 - Manual (Page 23)

Chapter 5 Driver Installation For Windows NT 3.51
Driver installation
1. In the Main group of NT, select the Control Panel icon.
2. In the Control Panel window, select the Network icon.
3. In the Network Settings dialog box, select the Add Adapter button. The Add
Network Adapter dialog box appears.
4. In the list of network cards, select <other> Requires disk from manufacturer , and
then press <Enter> button.
5. Insert this driver disk in drive A . Enter drive and pathname A:/ and click the OK
button.
6. In the Select OEM Option dialog box, the following adapter name is displayed.
Select this adapter and click the OK button to install it.
Macsense Fast Ethernet CardBus Card
7. The Macsense Fast Ethernet CardBus Card Setup dialog box appears. You should
specify the correct values of these parameters for MPC-200 to work. Check the sec-
tion on
NDIS 3 Driver Parameters for Windows NT 3.51 for more information about
how to configure the parameters.
8. The system copies MCBNDIS3.SYS from the \WINNT directory on the driver disk to
C:\WINNT\SYSTEM32\DRIVERS\MCBNDIS3.SYS, and the OEMSETNT.INF from
\WINNT351 to C:\WINNT\SYSTEM32 but gives it another name (e.g.
OEMNAD??.INF). If you remove the MPC-200 driver and would like to re-install it
later, you do not need the driver disk again. In the above, we assumed C:\WINNT is
the directory where the Windows NT system files are installed.
9. To complete network installation, remember binding the adapter to transport drivers
by selecting the Bindings button under the Network Setting dialog box.
10. Insert the Fast Ethernet CardBus Card in one of the CardBus sockets.
Attach the coupler to the back of the card, and connect a cable from the RJ-45 con-
nector on the back of the coupler to a hub or switch.
You can now shutdown and restart the computer. Please note during Windows NT
initialization, MPC-200 must be properly connected to a hub or switch; otherwise the card
and driver would not communicate correctly.
Note: If you are connected to a 100Mbps network, be sure to use UTP-5 or STP-1 cable.
Driver Installation for Windows NT 3.51
21