Macsense Connectivity MPC-200 - Manual (Page 37)

where [optional switches] are:
-h Get help screen
-il INTERRUPT LINE
Note: Use DECIMAL numbers for INTERRUPT LINE The default interrupt is 9
(when run with no switches).
Example:
This example shows the ADJIRQ command without switches. It has assigned IRQ 9
to the CardBus bridge.
C:\> ADJIRQ
+--------------------------------------------------------------------------------------+
| CardBus ADJIRQ V1.0, Copyright (c) 1998 Foresson Corporation |
+--------------------------------------------------------------------------------------+
Build Date: Sep 25 1998
Routing interrupt 9 to CardBus bridge
Found TI1130 bridge
Example:
This example shows the ADJIRQ command with interrupt number switch used. It
has assigned IRQ 10 to the CardBus bridge.
C:\> ADJIRQ -il 10
+--------------------------------------------------------------------------------------+
| CardBus ADJIRQ V1.0, Copyright (c) 1998 Foresson Corporation |
+--------------------------------------------------------------------------------------+
Build Date: Sep 25 1998
Routing interrupt 10 to CardBus bridge
Found TI1130 bridge
2. STARTER.EXE
PCI-to-CardBus bridges and CardBus devices behind the bridges, need to be con-
figured by software during power-up of a system. Typically configuration code in the
systems BIOS will perform this function. These utilities are written to be used on
systems with BIOS that doesn't have PCB support yet, so the PCB's and this
CardBus device downstream of the PCB's can be configured.
PCI to CardBus
38
Appendix B Error Messages of Enabler Programs