Macsense Connectivity MPC-200 - Manual (Page 29)

4. Turn off your computer and insert the Macsense Fast Ethernet CardBus Card into
the PC Card socket. Then attach the cable to the card.
5. Now turn your computer on and connect it to the network. If you cannot connect it to
the network, refer to the Appendix A and B.
The Install batch files
Before you can use your Macsense Fast Ethernet CardBus Card, you need to install
and modify some files in your computer system. You can make these changes by using
INSTALL batch files.
¥ INSTNWCL.BAT NetWare Driver Installation Batch File
¥ INSTWFW.BAT Windows For Workgroups Driver Installation Batch File
DOS ODI Client Driver Installation NetWare 3.x / 4.x Client
To install ODI driver, type INSTNWCL from a:\, and add two command lines to your
autoexec.bat file.
Steps as following:
1. Turn on the power and run your computer in DOS mode.
2. Insert Macsense Fast Ethernet CardBus Card Driver Diskette in drive A:
3. Type A: and press ENTER key
4. Type INSTNWCL and press ENTER key
5. Use MS-EDIT to add two command lines bellow to your AUTOEXEC.BAT file
PATH C:\NWCLIENT;%PATH%
C:\NWCLIENT\STARTCB.BAT
6. Reboot your computer
NOTE: The default directory for this install program to install files is named NWCLIENT.
The following ten files will be copied to LAN PC Card Netware driver directory:
LSL.COM supported by Novell
MCBODI.COM Novell DOS ODI Driver
IPXODI.COM supported by Novell
NETX.COM supported by Novell
NET.CFG optional, configuration file
28
Client Driver Installation