Document Outline

• Contents
  • 1 Introduction
  • 2 General Installation
  • 1. Unpacking the Scanner
  • 2. Unlocking the Carriage
  • 3. Resetting the scanner's SCSI ID
  • 4. Power-up test
  • A. Operating Voltage
  • B. Connecting the Scanner to Power Source
  • C. Powering up the Scanner
  • D. Observing the Scanner Boot Process
  • 5. Choosing the Scanning Station
  • Requirements for the Operating Environment
  • 3 Installation on the Macintosh
  • A. Installation for Macintosh computers with built-in SCSI ports
  • B. Installation for the new G3 Macintosh computers
  • 4 Installation on Windows 98 / 95
  • 1. Installing the interface card
  • 2. Checking the interface card status
  • 3. Installing the software
  • 4. Connecting the scanner
  • 5. Termination
  • 6. Troubleshooting
  • 5 Installation under Windows NT 4.0
  • 6 Operating the Scanner
  • 1. Positioning reflective materials
  • A. General scanning
  • B. Scanning thick documents
  • 2. Positioning transparent film
  • A. Using the Universal Glass Film Holder
  • B. Using the 35mm Slide Holder
  • C. Using the 35mm Filmstrip Holder
  • D. Using the 6 x 9 cm Film Holder
  • E. Using the 4" x 5" Film Holder
  • 7 Using the Scanner ICC Profiler Program
  • 1. Introduction
  • 2. Calibration target
  • 3. Taking care of the target
  • 4. Replacing the target
  • 5. Installing the Scanner ICC Profiler
  • A. For the Macintosh
  • B. For Windows 98 / 95 / NT 4.0
  • 6. Placing the color target
  • 7. Calibration
  • 8. Scanning the target image
  • 9. Aligning the target registration marks
  • A. Aligning the upper-left registration mark
  • B. Aligning the upper-right registration mark
  • C. Aligning the bottom-right registration mark
  • 10. Creating a profile 29
  • 11. Reference Section for Macintosh
  • A. Menu commands
  • B. The Main Window
  • C. The Calibration Window: Preview and Scan
  • D. The Calibration Window: Aligning targets and creating the profile
  • 12. Reference section for PC
  • A. The Main Window
  • B. The Calibration Window: Preview and Scan
  • C. The Calibration Window: Aligning targets and creating the profile