Marshall electronic Network Control Box for IMD Monitors NCB-1004 - Manual (Page 12)

12
Changing the IP Address of the NCB-1004 (continued)
Procedure (continued)
8. The following file information should appear:
9. This file must be edited to save the new IP address. Use the following commands to edit the file. Edit only the
numbers. Do not press the enter key after each command.
To move the cursor, use arrow keys or the following keys:
h left
l right
j down
k up
To edit the text, use the following keys:
x delete single character under cursor
r replace single character under cursor with single character
i insert characters before cursor (press esc when finished typing)
a insert characters after cursor (press esc when finished typing)
Save the file and exit the file editor using the following commands:
ZZ exit and save changes
:q! exit without saving changes
:w save file without exiting
10. Be sure to note the new IP address. Reboot the NCB-1004 for the new IP address to take effect.