Marshall electronic Network Control Box for IMD Monitors NCB-1004 - Manual (Page 18)

18
Web Interface (continued)
Preset Configuration
The Preset Configuration page is shown below:
Use the buttons shown above to load and save presets in each monitor. Note that these controls affect the presets in
each monitor only. There are no presets in the NCB-1004 itself.
o Load (Load presets User1 – User6, or Factory Default Settings)
o Save (Save the current settings on each monitor to presets User1 – User6)
Test Mode
The Test Mode page is shown below:
Use the buttons shown above to send the following commands:
o Reset Test Mode – This command turns Blue mode, Monochrome Mode, and PixelToPixel mode OFF.
o Blue Mode (Off, On)
o Monochrome Mode (Off, On)
o PixelToPixel Mode (Off, On)