Marshall electronic Network Control Box for IMD Monitors NCB-1004 - Manual (Page 13)

13
System Configuration
Overview
The NCB-1004 can be used in three different system configurations. The following diagrams show the different
configurations:
Basic Remote Control of IMD Monitors
■ Overview
Use the following configuration for basic remote control of Marshall IMD series monitors. This setup allows remote
control of all features in the on-screen menu of each IMD monitor.
■ Wiring Diagram
Use the following configuration for basic remote control of Marshall IMD series monitors.
■ Monitor Configuration
The following settings are required on each IMD monitor:
IMD Protocol: MEI
IMD Baud Rate: 57600
ID#: Each monitor must have a unique ID# for remote control of individual monitors.
PC
Ethernet Cable to
Network Connection
on NCB-1004
Marshall
IMD
Marshall
IMD
Marshall
IMD
Marshall
IMD
Marshall
IMD
Marshall
IMD
Marshall
IMD
Marshall
IMD
Marshall
IMD
Marshall
IMD
Marshall
IMD
Marshall
IMD
Network
PC
Connect monitors to RS-422 Outputs on
Marshal IMD Monitors. Use up to 4 RS-422
outputs on NCB-1004.
Use 6P6C Modular Cable, wired pin-to-pin.
Use second RS-422 jack on
each monitor to daisy-chain
multiple monitors.
Connect up to 128
IMD screens per RS-
422 output