Marshall electronic Network Control Box for IMD Monitors NCB-1004 - Manual (Page 21)

21
Web Interface (continued)
Table of Web Interface Commands
Aspect Ratio 4:3, Scaled 4:3, 16:9, 16:9 Centered
Set Marker Off, On
Window Management Set Center Off, On
Set Background Transparent, 50% Gray, Black
Set Curtain Color Blue, Red, Green, White, Black
Menu Controls Menu, Select, Up, Down, F1, F2 Power
Color
Increase Value, Decrease Value, Default, Set
Value, Get Value
Key & Image Enhancement Brightness
Increase Value, Decrease Value, Default, Set
Value, Get Value
Contrast
Increase Value, Decrease Value, Default, Set
Value, Get Value
Color Temp 55K, 65K, 93K, Linear
Preset Configuration Load
Mfg, User 1, User 2, User 3, User 4, User 5, User 6
Save User 1, User 2, User 3, User 4, User 5, User 6
Reset Test Mode Restore Test Mode Defaults
Test Mode Blue Only Off, On
Monochrome Off, On
Pixel-to-Pixel Off, On
Set Protocol Image Video, TSL
Main Pass-Through On, Off
Protocol Type Verify Protocol Type
TSL Status Verify TSL Status
IMD State Off, On
Status Display Off, On
Timecode Off, LTC, VITC
Audio Monitor Off, On
OSD Configuration & IMD Show IMD Address Display Address On-Screen
Set IMD Inensity Set Value
Send IMD Alignment Left, Center, Right
Send IMD Color Red, Green, Yellow/Amber
Send IMD String Send String
Send IMD Name Send Name
Get IMD Name Get Name
Show IMD Display IMD String On-Screem
Show IMD Name Display IMD Name On-Screen
Ping
Healthy, Unhealthy
Get Software Version Display Software Version
Get Protocol Version Display Protocol Version
System Get Keypad Version Display Keypad Version
Get Model Number
Display Model Number
Protocol Standby Enable Protocol Standby
System Reset Enable System Reset
Set Power State Off, On