Marshall electronic Network Control Box for IMD Monitors NCB-1004 - Manual (Page 16)

16
Web Interface
Overview
The web interface is used to operate the NCB-1004. Once the NCB-1004 is connected to a network, access the web
interface by entering the units IP address in any web browser on any computer on the network. The web interface allows
remote control of all on-screen menu features of individual monitors or all monitors connected. The web interface also
controls the pass-through of Image Video or TSL protocol.
Target Monitor
The target monitor frame is always visible at the top of the NCB-1004 web page:
■ Target Monitor
On the right side of the frame, choose which monitors to address:
o When the “All/Global” option is selected, all commands will be globally sent to all IMD monitors connected to
the NCB-1004.
o When the “Address” option is selected, all commands will be sent only to the IMD monitor with the ID# in the
adjacent field.
Note that to control individual monitors, each monitor must be pre-assigned a unique ID#. Also note that GET
commands do not work in “All/Global” mode.
■ Protocol Pass-Through Status
On the right side of the frame, two windows show the protocol pass-through status:
o The first window displays “Image Video Protocol” or “TSL 4.0 Protocol,” according to which protocol is selected
for pass-through in the OSD Configuration & IMD page.
o The second window displays “Pass-Through: ON” or “Pass-Through: OFF,” according to the pass-through
setting in the OSD Configuration & IMD page.