Minolta Color PageWorks 0990-7701-02 - Manual (Page 26)

13
CHAPTER 1
In
stallation
SIMM2
Controller board (a)
3. Setting-Up
8
- Check that the PostScript ROM is mounted
securely.
7
5
- Insert the controller board into the guide rails.
- Secure the controller board in position with the
four screws.
- Take the PostScript ROM out of its carton.
- Check which type of Controller board is installed
in your printer.
- Mount the PostScript ROM in the socket
(SIMM2) at the location shown on the controller
board.
10
9
6
- Push the PostScript ROM down in the direction of
the arrow.
- This completes the procedure to mount the
PostScript ROM in the printer.
- You now install the printer driver (software).
Read the PostScript User’s Guide separately
provided (that is shipped together with the
accessories that come with this Adobe
PostScript ROMM SIMM set) and install the
printer driver according to the operating system
of the host computer to be used.
- Reconnect the interface cable or network cable.
- Insert the PostScript ROM pin into the socket.
11
Left Side Right Side
Controller board (b)
SIMM2