Multi-Tech Systems MVP103 - Manual (Page 21)

Chapter 2 - Configuration
Multi-Tech Systems, Inc. Avaya Communication Manager Guide 21
7c. To add an entry for MultiVOIP FXO ports, configure Endpoint Type, Product ID, Names,
Registration IP, and Call Signalling Port fields as indicated below. Configure the Names field
with a unique descriptive identifier for the FXO trunk. This same name will be used later to map
Outbound Phone Book entries with specific digit patterns (area codes, etc.) to this FXO trunk, and
for Caller ID purposes in survivable mode. The Registration IP should match the IP address of the
MultiVOIP where the port is located. This could be the IP address of this very same MultiVOIP or
another MultiVOIP. Leave the other fields blank. Only one entry is required for one or more ports
on a given MultiVOIP. For example, if the MultiVOIP has four FXO ports, only one gatekeeper
entry should be added. Click OK to accept this entry.
7d. To add an entry for MultiVOIP DID ports, configure Endpoint Type, Product ID, Names,
Registration IP, and Call Signalling Port fields as indicated below. Configure the Names field
with a unique descriptive identifier for the DID trunk. This name will be used for Caller ID
purposes in survivable mode. The Registration IP should match the IP address of the MultiVOIP
where the DID port is located. This could be the IP address of this very same MultiVOIP or another
MultiVOIP. Leave the other fields blank. Only one entry is required for one or more ports on a
given MultiVOIP. For example, if the MultiVOIP has four DID ports, only one gatekeeper entry
should be added. Click OK to accept this entry.