Multi-Tech Systems MVP103 - Manual (Page 32)

Chapter 2 – Configuration
32 Multi-Tech Systems, Inc. Avaya Communication Manager Guide
The Custom Tone-Pair Settings fields are described in the table below.
Custom Tone-Pair Settings Definitions
Field Name Values Description
Tone Pair dial tone, busy tone,
ring tone, ‘unobtainable’
tone, survivability tone,
re-order tone Identifies the type of telephony signaling tone for which
frequencies are being specified.
TONE PAIR VALUES About Defaults : US telephony values are used as defaults on
this screen. However, since this dialog box is provided to allow
custom tone-pair settings, default values are essentially
irrelevant.
Frequency 1 frequency in Hertz Frequency of lower tone of pair.
This outbound tone pair enters the MultiVOIP at the input port.
Frequency 2 frequency in Hertz Frequency of higher tone of pair.
This outbound tone pair enters the MultiVOIP at the input port.
Gain 1 gain in dB
+3dB to –31dB
and “mute” setting Amplification factor of lower frequency of pair. This figure
describes amplification that the MultiVOIP applies to outbound
tones entering the MultiVOIP at
the input port. Default = -16dB
Gain 2 gain in dB
+3dB to –31dB
and “mute” setting Amplification factor of higher frequency of pair. This figure
describes amplification that the MultiVOIP applies to outbound
tones entering the MultiVOIP at
the input port. Default = -16dB
Cadence 1 integer time value in
milli-seconds; zero
value for dial-tone
indicates continuous
tone On/off pattern of tone durations used to denote phone ringing,
phone busy, dial tone (“0” indicates continuous tone)
survivability and re-order. Cadence 1 is duration of first period
of tone being “on” in the cadence of the telephony signal (which
could be ring-tone, busy-tone, unobtainable-tone, or dial-tone).
Cadence 2 duration in milliseconds Cadence 2 is duration of first “off” period in signaling cadence.
Cadence 3 duration in milliseconds Cadence 3 is duration of second “on” period in signaling
cadence.
Cadence 4 duration in milliseconds Cadence 4 is duration of second “off” period in the signaling
cadence, after which the 4-part cadence pattern of the telephony
signal repeats.