MGE UPS Systems 3.5 to 21 kVA N+1 - Manual (Page 20)

2.3 Mechanical Mounting
The equipment can be floor mounted or rack mounted in a 19” (48.3 cm), 23” (58.4 cm), or 25” (63.5 cm) rack.
Optional mounting bracket kits can be ordered for rack mounting in a 25” (63.5 cm) or 26” (66.0 cm) rack.
All receivers and inverter power modules are shipped separately from the factory. Receivers will be shipped on a
pallet. These receivers can be secured to a floor or to some other permanent base using one-half inch bolts through
the four holes in the base supports. The inverter modules will be shipped based on customer’s discretion on power
configuration or the size of the receiver they are using. Modules will be shipped separately from exterior chassis.
Refer to Figure 2-2 on page 2—3.
Figure 2-1: Installation Drawing, 7 kVA Inverter System.
Installation & Operation
3.5 to 21 kVA N+1 Inverter
page 2 — 2
FOR 1" (2.54 cm),
1-1/2" (3.81cm)
CONDUITS
FOR 1" (2.54 cm),
2" (5.08 cm), 3" (7.62 cm)
CONDUITS
FOR 1/2" (1.27 cm), 3/4" (1.90 cm)
CONDUITS (2 PLACES)
12.210
(31.00 cm)
1.650 (4.19 cm) 3.250
(8.26 cm)
2.825 (17.18 cm)
8.870
(22.53 cm )
16.060
(40.80)
15.775
(40.07 cm)
11.675
(29.65 cm)
8.925
(22.67 cm)
FOR 1" (2.54 cm),
2" (5.08 cm), 3" (7.62 cm)
CONDUITS
FOR 1" (2.54 cm),
1-1/2" (3.81cm)
CONDUITS
TOP VIEW
LEFT SIDE VIEW