Figure 28: invalid key entry window, Figure 29: canopy t1/e1 mux configuration window, Figure 28 – Motorola T1/E1 User Manual
Page 62
Advertising
Canopy T1/E1 Multiplexer
September 2004
T1/E1 Multiplexer FPGA Version 3.4
Page 62 of 73
Figure 28: Invalid key entry window
NOTE: At any later date, you can confirm the number of enabled ports as follows.
4. From the main menu, select Config
→Canopy T1/E1 Mux.
RESULT: The Canopy T1/E1 Mux Configuration window opens, as shown in
Figure 29: Canopy T1/E1 Mux Configuration window
5. In the lower right quadrant of the window, find the Enabled T1/E1 Ports block.
NOTE: Each enabled port is identified by a black check mark.
end of procedure
Issue 3
Advertising