Muratec MFX-3070 - Manual (Page 144)

144 • Maintenance
3. Holding it by its top centre, lift the image drum, complete with its toner cartridge,
up and out of the MFP.
4. Put the cartridge down gently onto a piece of paper to prevent toner from
marking your furniture and to avoid damaging the green drum surface.
Caution!
The green image drum surface at the base of the cartridge is very
delicate and light sensitive. Do not touch it and do not expose it to
normal room light for more than 5 minutes. If the drum unit needs to
be out of the MFP for longer than this, please wrap the cartridge
inside a black plastic bag to keep it away from light. Never expose
the drum to direct sunlight or very bright room lighting.
5. With the colored toner release lever to the right, pull the lever towards you. This
will release the bond between the toner cartridge and the image drum cartridge.
6. Lift the right-hand end of the cartridge and then draw the cartridge to the right to
release the left-hand end as shown, and withdraw the toner cartridge out of the
image drum cartridge. Place the cartridge on a piece of paper to avoid marking
your furniture.
7. Take the new image drum cartridge out of its packaging and place it on the piece
of paper where the old cartridge was placed. Keep it the same way round as the
old unit. Pack the old cartridge inside the packaging material for disposal.