Moyer Diebel MH-6NM2 - Manual (Page 11)

To Change from
Straight-through Operation
to Corner Operation
The dishwasher is shipped from the factory
for straight-through operation. The following
instructions explain how to change the dishwasher
for corner operation.
Refer to Fig. 2
1. Place the dishwasher so that operator
controls are readily accessible.
2. Minimum clearance from any wall is
5-1/4" (133mm).
Refer to Fig. 3a-3b and perform the steps below.
1. Remove the front rack guide (A).
Discard the square spacers.
2. Move front rack guide (A) to the right side of
the rack tracks. (See Fig. 3b) Use existing
hardware.
3. Unbolt the track (B) and rack support rod (C).
4. Remove and save the two remaining fasteners
from rear track.
5. Bolt (B) and (C) as shown in Fig. 3b.
INSTALLATION
9
Figure 2
Placement for Corner Operation
Figure 3a
Straight-Through Configuration
Figure 3
Change the Track Assembly
A
A
B
B C
C
Figure 3b
Corner Configuration
5-1/4"[133mm] MIN.
5-1/4"[133mm] MIN.
WALL
WALL
FRONT
POWER ON
SWITCH
Do not place the dishwasher closer than 5-1/4" (133mm) to any wall.
Note:
Power switch is
readily accessible.
5-1/4"[133mm] MIN.
5-1/4"[133mm] MIN.
WALL
WALL
FRONT
POWER ON
SWITCH