Moyer Diebel MH-6NM2 - Manual (Page 13)

Electrical Connections (Cont.)
Refer to Fig. 5
3. Remove (2) lower screws from the front
panel of the machine to expose the electri-
cal controls. Loosen (1) screw on the
control panel support post. Slide the
support post up to disengage the post from
the machine base. Swing the hinged
control panel forward.
Refer to Fig. 6
4. Three phase or single phase incoming
power wiring connections are made at the
bottom of the machine’s main terminal
block. The main terminal block is located
on the side of the front right post of the
dishwasher.
INSTALLATION
Figure 5
Hinged Control Panel
11
Electrical Power Connection
Figure 6
Main Terminal Block