Precautions – Motorola SURFBOARD SVG2500 User Manual
Page 34
2 INSTALLATION
19
You must have the latest service packs and patches installed on your computer for
your operating system. You will need 75-ohm
with F-type connectors to
connect the SVG2500 to the nearest cable outlet. If a TV is connected to the cable
outlet, you may need a 5 to 900 MHz RF
and two additional coaxial cables to
use both the TV and the SVG2500.
Determine the connection types you will make to the SVG2500. Check that you have
the required cables, adapters, and adapter software. You may need:
Wireless LAN
Wireless adapter and driver software for each computer having a wireless
connection.
Wired Ethernet
Ethernet cables and network interface cards (NICs) with accompanying
installation software
LAN
To connect more than four computers to the SVG2500, one or more Ethernet
hubs or switches
USB
A USB cable and the SVG2500 Installation CD-ROM containing the software
for USB installation
Coaxial cable, RF splitters, hubs, and switches are available at consumer electronic stores.
Precautions
Postpone SVG2500 installation until there is no risk of thunderstorm or lightning
activity in the area.
To avoid potential shock, always unplug the power cord from the wall outlet or other
power source before disconnecting it from the SVG2500 rear panel.
To prevent overheating the SVG2500, do not block the ventilation holes on the sides
of the unit. Do not open the unit. Refer all service to your Internet Service provider.
Wipe the unit with a clean, dry cloth. Never use cleaning fluid or similar chemicals.
Do not spray cleaners directly on the unit or use forced air to remove dust.