Moxa Technologies CP-132U - Manual (Page 47)

Software Installation
CP-132U Series User’s Manual 3-31
2. Click on the desired CP-168U board, and then click on [Properties].
3. Select the [Ports Configuration] tab, click on the specific port, and then click on the
[Port Setting] button.
4. Check the Auto Enumerating COM Name check-box to assign continuous COM
numbers for subsequent ports. For example, if COM3 is assigned to Port 1, then COM4
will be automatically assigned to Port 2.
5. Select an Rx FIFO Trigger from the Rx FIFO Level pull-down list. Rx FIFO trigger
levels from High to Low are available, with the default set to High (120 bytes). Check
the Set the change to all ports check-box to apply the just defined Rx FIFO Trigger to