Multi-Tech Systems MT5634ZPX-PCI-V92 - Manual (Page 17)

2 Installation
12
MultiModemZPX User Guide
6. In the Configure Port Usage dialog box, select Dial out only, Receive calls
only , or Dial out and receive calls, depending upon how the phone line will be
used. Click OK.
7. In the Remote Access Setup dialog box, click Network.
8. In the Network Configuration dialog box, make sure that only TCP/IP is select-
ed, and then click OK.
9. If there is a network interface card that does not have TCP/IP bound to it, the
Microsoft TCP/IP Properties window appears. Click Cancel to close the window.
10. Click Continue, and then click Restart to finish the installation.
11. After completing the hardware and driver installation, you must configure your
modem for country-specific operation. See “Step 4: Configure the Modem for
Your Country” for configuration instructions.
12. After setting up your modem for country-specific operation, you’ll want to con-
figure your communications software or Windows Dial-Up Networking. Infor-
mation about configuring your communications software can be found in Step 5.
If Dial-Up Networking is already installed
1. Double-click the My Computer icon, then the Control Panel icon, and then the
Network icon.
2. In the Network dialog box, click the Services tab, and then double-click Remote
Access Service.
3. In the Remote Access Setup dialog box, a list of modems is displayed. Click Add.
4. In the Add RAS Device dialog box, choose Multi-Tech Systems MT5634ZPX-
PCI-V92 , and then click OK.
5. In the Remote Access Setup dialog box, click Configure.
6. In the Configure Port Usage dialog box, select Dial out only, Receive calls
only , or Dial out and receive calls, depending upon how the phone line will be
used. Click OK.
7. In the Remote Access Setup dialog box, click Continue.
8. The system processes the new information and the Network Settings Change
dialog box appears. Select Yes to restart your computer.
9. After completing the hardware and driver installation, you must configure your
modem for country-specific operation. See “Step 4: Configure the Modem for
Your Country” for configuration instructions.
10. After setting up your modem for country-specific operation, you’ll want to con-
figure your communications software or Windows Dial-Up Networking. Infor-
mation about configuring your communications software can be found in Step 5.